GRAPHTEC FC8600-160 - Page 107

FC8600-UM-251-9370 8-4
8 TROUBLESHOOTING
Error
code
Error Display Cause Verication item Solution
E01014
X or Y motor is
defective.
Or the main board is
defective.
Replace the X or Y
motor.
Or replace the main
board.
E01015
E01017 Load on the motor
was too large.
Check the madia. Do not use heavy
media.
Use the prefeed
function.
Cutting conditions do
not suit the cutting
medium.
Cutting conditions. Lower the cutting
SPEED and/or the
cutting FORCE.
Movement of the X is
being obstructed.
Is there anything
blocking the X
movement?
Turn off the plotter,
remove the obstacle,
then turn the plotter
back on.
Excessive load is
causing the current to
the motor to exceed
the rated value.
Does the X move
smoothly?
No .....Check and adjust
the X belt tension
and X motor belt
tension.
Yes ....Verify item (2).
Is the X exible cable
securely connected?
Or Is the X exible
cable broken?
No .....Connect it
securely.
Yes ....Replace the X
exible cable if
defective.
Motor Does the X-motor
turn smoothly?
No .....Replace the
X-motor if
defective.
Yes ....Replace the main
board if defective.