FC8600-UM-251-9370 7-7
7 ADJUSTMENT
(6) Spread the screw-lock-glue (1401B) to the adjustment screw after the push roller force was adjusted.
(7) Tighten the screw (upper screw) holding the force adjustment bracket as shown in the picture below.
Tighten this screw.
(8) Set the push roller force lever to the lower position for the high force.
(9) Loosen the screw (Lower screw) holding the bracket as shown in the picture below.
Loosen this screw.
(10) Conrmthereisnogapbetweenthetopoftensionleverandthebottomoftensionbracket.
Conrmthereisnogaphere.
To Next Page
Loading...
