GRAPHTEC FC8600-160 - Page 71

FC8600-UM-251-9370 7-11
7 ADJUSTMENT
(10) Loosen the lower position adjustment screw, and then gently tighten the lower position adjustment
screw until the screw hit to the inside of parts.
Don’t tighten this screw strongly.
Top part of the bracket will be bent if you tighten this screw strongly.
Lower position adjustment screw
(11) Conrmthereisnogapbetweenthetopoftensionandthebottomoftensionbracket.
Conrmherethereisnogap
between the top of tension and
the bottom of tension bracket.
(12) Spread the screw-lock-glue (1401B) to the lower position adjustment screw after the lower position was
adjusted.
Lower position adjustment screw