GRASS VALLEY K2 - SCSI Interface Board Removal

110 K2 Media Client Service Manual July 28, 2008
Chapter 5 Removing and replacing FRUs
SCSI interface board removal
To remove the SCSI interface board, first remove the top cover and the front panel,
then proceed as illustrated.
Refer to “SCSI controller adapter removal” on page 123 for cable detail on RAID
controller adapter to identify SCSI 0 and SCSI 1 cables.
2
Remove SCSI 1
cable*
3
Remove power
distribution cables
1
Remove SCSI 0
cable*
Trace SCSI cables to
RAID controller adapter
to identify
*
The motherboard cable is not
present on older versions of
the SCSI interface board
**
6
Remove fan
power cable
5
Remove USB
cable
4
Remove motherboard
cable**
7
Remove six screws
8
Disengage from
backplane
9
Slide out through
front