July 28, 2008 K2 Media Client Service Manual 95
Timecode problems
Timecode problems
For the corrective actions in this section, refer to the K2 Media Client User Guide for
detailed instructions
Problem Possible Causes Corrective Actions
Recorded timecode reads
xx.xx.xx.xx.
No timecode source for the
channel.
Set the timecode source.
A clip shows no mark-in/
mark-out timecode, the current
timecode display shows
XX:XX:XX:XX, or the last
valid timecode is displayed.
The selected timecode source
was missing or intermittent
during recording.
Check that you have the right
record channel timecode source
selected, verify that timecode is
present in the source, and record
the clip again. You can also
stripe the timecode on an
existing clip.
To Next Page
Loading...
