GRASS VALLEY K2 - Reorder Adapters

56 K2 Media Client Service Manual July 28, 2008
Chapter 3 Service Procedures
2. Identify the adapter that in the “Device Name” column is labeled “TEAM : Control
Team”. Rename the adapter follows:
a. Click the Adapter Name.
b. Select
File | Rename to enter rename mode.
c. Type Control Team.
3. Ensure that eight entries are named as follows in Network Properties:
4. Set an IP address for the Control Team. Use standard Windows procedures.
Do not set IP addresses for the two Media Connections, as these must be configured
only by the K2 System Configuration application as part of configuring the K2
Storage System.
Continue with the next procedure “Reorder adapters”.
Reorder adapters
1. On the Windows desktop right-click My Network Places and select Properties. The
Network Connections window opens.
2. On the menu bar at the top of the window, select
Advanced, then Advanced
Settings…
3. On the Adapters and Bindings tab, depending on the K2 Media Client’s storage,
Name Device Name
…Connection #1 TEAM : Control Team - Intel® PRO/1000 MT Dual Port Server Adapter (Type 1 MB)
-or-
TEAM : Control Team - Intel® PRO/1000 EB Network Connection… (Type II and Type III MB)
…Connection #2 TEAM : Control Team - Intel® PRO/1000 MT Dual Port Server Adapter #3 (Type 1 MB)
-or-
TEAM : Control Team - Intel® PRO/1000 MT Dual Port Server Adapter (Type II and Type III MB)
Control Team TEAM : Control Team
…Connection #3 Team : DO NOT USE
a
a.
This team only on K2 Media Clients shipping before system software version 3.2.5x.
Loopback Microsoft Loopback Adapter
Media Connection #1 TEAM : Media Team - Intel® PRO/1000 MT Dual Port Server Adapter #2 (Type 1 MB)
-or-
TEAM : Media Team - Intel® PRO/1000 EB Network Connection…#2 (Type II and Type III MB)
Media Connection #2 TEAM : Media Team - Intel® PRO/1000 MT Dual Port Server Adapter #4 (Type 1 MB)
-or-
TEAM : Control Team - Intel® PRO/1000 MT Dual Port Server Adapter #2 (Type II and Type III
MB)