July 28, 2008 K2 Media Client Service Manual 115
RTP board removal
RTP board removal
To remove the RTP board, first remove the top cover and the codec board, then
proceed as illustrated.
On HD-00 models the RTP board is in rear panel slot two, as shown. On other models
the RTP board is in rear panel slot five.
After installing the replacement RTP board, install the current version of K2 Media
Client software. (Note: An over-install is all that is required. You do not need to first
un-install the software.) This ensures that the board is flashed with the proper version
to be compatible with K2 Media Client software.
LIft lever to
disengage
board
3
Lift board
straight up
4
Remove
screw
2
Loosen retaining screws
on adjacent boards to allow
the RTP board to move in the
rear panel slot.
1
Keep board aligned front and
rear when sliding out and in.
To Next Page
Loading...
