GRASS VALLEY K2 - Page 113

July 28, 2008 K2 Media Client Service Manual 113
Codec board removal
installing the replacement board, make sure screws are installed in the proper
sequence, as illustrated:
Loosely install
center screw
3
Install side
screws tightly
4
Tighten
center
screw
5
Install side
screws
6
Install side
screws
6
Install center
rear screw
7
Connect large
power cable
On HD-00 models,
also connect
small power cable
8
Carefully engage the
RTP board
2
Move board into position,
then reach under and
connect XLR board cable
1