controller):
In ―n7‖ status, the timer zone is not displayed. Press ―MODE‖ button
to enter parameter query of outdoor unit. The first bit in the
temperature zone (display bit of the outdoor unit module ID) blinks.
Press "▲" or "▼" to switch the outdoor unit module ID. Press "MODE"
button to select an outdoor unit module. In this case, the first bit in the
temperature zone stops blinking, and the second and third bits in the
temperature zone display the parameter code. The timer zone
displays a corresponding parameter value. Press "▲" or "▼" to
switch the parameter code and press the ―SWING/ENTER‖ button to
return to the upper-level menu.
Display mode:
Temperature zone displays the outdoor unit module ID and parameter
code from left to right.
Timer zone displays a corresponding parameter value on the right.
To Next Page
Loading...