Chapter 3: Installation
3. If necessary, use the 1/2" x 4-1/2" HHTB bolt (2) and 1/2" flange nuts (41) in the hanger bracket
assembly (86) to adjust the height of the auger off the floor for clearance.
Figure 3-38 Adjusting the sweep support skid
2 1/2" x 4-1/2" HHTB bolt 86 Hanger bracket assembly
41 1/2" flange nut 105 Sweep support skid
51 1/2" lock nut
PNEG-2308 Chain Loop Power Sweep
43
To Next Page
Loading...