PEL-3000(H) User Manual
138
Last step number (0001-1000)
per loop
Sets the step execution time.
Each step in a fast sequence contains the following
setting parameters:
Selects/displays the current
step in the sequence.
The number of available
steps is dependent on the
number of steps added
using the Ins. Point[F1]
functions.
A minimum of 3 steps.
The current or resistance setting
for the selected operating mode.
When TRIG OUT is set to ON, a
trigger signal is output from the
TRIG OUT BNC terminal at the
start of the step. See page 185
for details.
Time
amplitude
TRIG OUT = ON
TRIG OUT
Start of step
The FILL function is used to evenly step up the
current or resistance value settings from a starting
step to a finishing step.
To Next Page
