GW Instek PSW Series Programming Manual

REMOTE CONTROL
39
Status Commands
STATus:OPERation[:EVENt] ............................................39
STATus:OPERation:CONDition ....................................... 39
STATus:OPERation:ENABle ............................................. 39
STATus:OPERation:PTRansition ....................................... 40
STATus:OPERation:NTRansition ...................................... 40
STATus:QUEStionable[:EVENt] ....................................... 40
STATus:QUEStionable:CONDition .................................. 41
STATus:QUEStionable:ENABle ........................................ 41
STATus:QUEStionable:PTRansition .................................. 41
STATus:QUEStionable:NTRansition ................................. 41
STATus:PRESet .................................................................... 42
STATus:OPERation[:EVENt]
Query
Description
Queries the Operation Status Event register and
clears the contents of the register.
Syntax STATus:OPERation[:EVENt]?
Return <NR1>
Returns the bit sum of the Operation Status
Event register.
STATus:OPERation:CONDition
Query
Description
Queries the Operation Status register. This query
will not clear the register.
Syntax STATus:OPERation:CONDition?
Return <NR1>
Returns the bit sum of the Operation
Condition register.
STATus:OPERation:ENABle
Set
Query
Description
Sets or queries the bit sum of the Operation Status
Enable register.

GW Instek PSW Series Specifications

General

Ripple & Noise (CC)	≤ 3mArms
Protections	OVP, OCP, OTP
Remote Sense	Yes
Programmable	Yes
Operating Temperature	0°C to 40°C
Storage Temperature	-20°C to 70°C
Voltage Resolution	1mV
Current Resolution	1mA
Current Accuracy	±0.1% + 10mA
Ripple & Noise (CV)	≤1mVrms
Load Regulation (CC)	≤0.1% + 5mA
Line Regulation (CC)	≤0.1% + 5mA
Remote Interface	USB, RS232
Display	LCD