GW Instek PSW Series Programming Manual

GETTING STARTED
17
Configuration Settings
Setting Configuration Settings
Background
The normal configuration settings (F-01~F-61)
are used to configure system settings. Use the
following operation steps when configuring the
interface settings used in the Remote Control
chapter on page 18.
 Ensure the load is not connected.
 Ensure the output is off.
Note
Configuration settings F-90~F-95 cannot be edited
in the Normal Function Settings. See the user
manual for details.
Steps
1. Press the Function key. The
function key will light up.
2. The display will show F-01
on the top and the
configuration setting for
F-01 on the bottom.
3. Rotate the voltage knob to change
the F setting.
Voltage
Range
F-00~ F-61
4. Use the current knob to set the
parameter for the chosen F setting.

GW Instek PSW Series Specifications

General

Ripple & Noise (CC)	≤ 3mArms
Protections	OVP, OCP, OTP
Remote Sense	Yes
Programmable	Yes
Operating Temperature	0°C to 40°C
Storage Temperature	-20°C to 70°C
Voltage Resolution	1mV
Current Resolution	1mA
Current Accuracy	±0.1% + 10mA
Ripple & Noise (CV)	≤1mVrms
Load Regulation (CC)	≤0.1% + 5mA
Line Regulation (CC)	≤0.1% + 5mA
Remote Interface	USB, RS232
Display	LCD