GW Instek PSW Series - Commands System:configure:bleeder:state; System:configure:bleeder:state; System:configure:btrip:protection; System:configure:btrip[:Immediate]

PSW Series User Manual
52
SYSTem:CONFigure:BLEeder:STATe
Set
Query
Description
Sets or queries the status of the bleeder resistor.
Syntax
Query Syntax
SYSTem:CONFigure:BLEeder[:STATe] {OFF|ON|0|1}
SYSTem:CONFigure:BLEeder[:STATe]?
Parameter 0
<NR1> Turns the bleeder resistor off.
OFF
Turns the bleeder resistor off.
1
<NR1> Turns the bleeder resistor on.
ON
Turns the bleeder resistor on.
Return parameter <Boolean>
Returns bleeder resistor status.
SYSTem:CONFigure:BTRip[:IMMediate]
Set
Description
Trips the power switch trip (circuit breaker) to
turn the unit off (shut down the power).
Syntax SYSTem:CONFigure:BTRip[:IMMediate]
SYSTem:CONFigure:BTRip:PROTection
Set
Query
Description
Enables/Disables the power switch trip (circuit
breaker) when the OVP or OCP protection settings
are tripped. This setting only applies after power
has been reset.
Syntax SYSTem:CONFigure:BTRip:PROTection {OFF|ON|0|1}
Query Syntax SYSTem:CONFigure:BTRip:PROTection?
Parameter
0
<NR1> Disables the power switch trip for
OVP or OCP.
OFF
Disables the power switch trip for OVP or
OCP.
1
<NR1> Enables the power switch trip for
OVP or OCP.
ON
Enables the power switch trip for OVP or
OCP.
Return parameter <Boolean>
Returns power switch trip setting.