H3C S3600 Series Installation Manual

Installation Manual
H3C S3600 Series Ethernet Switches Chapter 3 Installation
3-3
When you install S3600 series into 19” standard cabinets, you should select front and
rear mounting ears listed in
Table 3-2.
Table 3-2 Selection of mounting ears for the S3600 series
Model
Physical
dimensions
Configuratio
n type of
front
mounting ear
Configuration
type of rear
mounting ear
z H3C S3600-28P-SI
z H3C S3600-28TP-SI
z H3C S3600-52P-SI
z H3C S3600-28P-EI
z H3C S3600-28F-EI
z H3C S3600-52P-EI
43.6 × 440 × 260
mm (1.7 × 17.3 ×
10.2 in)
Standard —
z H3C S3600-28P-PWR-SI
z H3C S3600-28P-PWR-EI
z H3C S3600-52P-PWR-SI
z H3C S3600-52P-PWR-EI
43.6 × 440 × 420
mm (1.7 × 17.3 ×
16.5 in)
Standard Standard
II. Use front mounting ears to install a switch
Follow these steps to mount a switch into a 19-inch standard cabinet:
1) Wear an ESD-preventive wrist strap and check the grounding and stability of the
cabinet.
2) Take out the screws which are packed together with the front mounting ears, and
fix one end of mounting ears to the switch, as shown in
Figure 3-3.
Front panel
Figure 3-3 Fix front mounting ears (1)
3) Place the switch horizontally in a proper position, and fix the other end of mounting
ears to the front brackets with screws and captive nuts, as shown in
Figure 3-4.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English