4. Connect the remote indicator cable to the remote indicator connector as follows:
a. Put the small flat-bladed screwdriver between the pin 1 orange tabs on the connector. Push
and hold to open the contacts for wire insertion.
b. Put the applicable colored wire for Terminal 1 in Terminal 1. Refer to Table 6 for the wire color
for each terminal. Remove the screwdriver from the connector.
c. Gently pull on the installed wire to make sure that the wire is held securely. Make sure that no
bare wire shows.
d. Do steps a to c again for Terminals 2 to 8.
Table 6 Wiring information—remote indicator
Terminal Color Terminal Color
1 Brown 5 Green
2 Brown and white 6 Green and white
3 Blue 7 Orange
4 Blue and white 8 Orange and white
English 41
To Next Page
Loading...
