167
Convertable Type
Indoor Unit
3. Floor Type Installation
①
Fix four rubber feet to the bottom of the unit with *4×16 bolts and Φ12
spacers (applicable to oor type units only).
②
According to gure on the right, choose a certain direction to lead out drain
pipe; drain holes are available on both right and left sides; practical
conditions shall be considered. After deciding upon the directions to lead
out pipelines, wires and drain pipes, drill wall holes according to required
drilling processes.
③
Install wall mount rack according to gure below.
④
Installing Drain Pipe
In case of model 22-140, x drain pipes to drain holes on left and right sides (as shown in gure 4 and gure 5).
Install as follows (see gure below):
Plug drain pipe in water pan in the first place, as shown by figure, then, bind the two tight together and tie up
junction area with heat insulant.
Figure 4 Model AC092-242MCERA Figure 5 Model AC282-482MFERA
Model AC092-242MCERA
Heat Insulant
To Next Page
Loading...
