41
Subject to change without notice
HM1X0X Oscilloscopes Test and Adjustment
3.2.3 USB Driver selection
After opening “driver (D:)” (depends on the PC), “USB 2.0
TO RS232 Converter” and “Windows”, select the folder “win
2000_xp_2003”, win XP_2003_x64 or win 98se_me depending
on the operating system installed, and click OK.
3.2.4 Search and installation options
Please make the settings as seen from the screen dump and
continue with “Next” to start the USB driver installation.
3.2.5 Finishing the installation
After the installation has been successfully completed it is
indicated by the following information.
Please follow the instruction and close the Wizard by clicking
„Finish“. This starts a new installation dialog. Do not remove
the USB driver software CD!
3.2.6 Selection
This opens the “Found New Hardware Wizard” window on
the PC screen.
Click “No, not this time” and thereafter “Next” to continue.
3.2.7 Installation CD
Click “Install from a list or specifi c location (Advanced) and
thereafter “Next”.
To Next Page
Loading...
Need help?
General
