Wireless AP Router HNW300APN2
User Manual 31
Wireless ISP
In this mode, all Ethernet ports are bridged together and the wireless client will connect to ISP access point.
The NAT is enabled and PCs in Ethernet ports share the same IP to ISP through wireless LAN. You must set
the wireless to client mode first and connect to the ISP AP in Site-Survey page. The connection type can be
setup in WAN page by using PPPOE, DHCP client or static IP.
To change the Operation Mode:
1. From the left-hand menu, click on Quick Setup. The following page is displayed:
2. Click on the ratio of Wireless ISP and then click on Next>>.
To Next Page
Loading...
Need help?
General
