Wireless AP Router HNW300APN2
User Manual 9
3. Installation & Setup
Follow each step carefully and only go to the next step once you have completed the previous one.
Note: Be sure that you are well insulated from any power source to avoid electricity shock.
Note: Use only the manufacturer-approved power supply that shipped with the Wi-Fi Router.
1. Connect the power to the Wi-Fi Router by plugging the power supply into an appropriate
electrical outlet.
2. If the Power LED is off, refer to “Troubleshooting” for information.
3.1 Connection of Wi-Fi Router
1. Connect the RJ45 Ethernet cable from your xDSL/Cable Modem's Ethernet port to Wi-Fi Router's
WAN Port.
2. Connect the supplied RJ45 Ethernet cable from your PC's Ethernet port to any of the four Wi-Fi
Router's LAN Ports.
3. Connect the power adapter to the power inlet “Power” of the Wi-Fi Router and turn the “ON/OFF”
power switch of your Wi-Fi Router ON.
To Next Page
Loading...