Turn the main power breaker on.
Start the computer.
Turn on the four Emergency Stop Buttons on each corner of the printer.
Then press the green “Power/Start” button for activation.
Run the self-checking on the initial start of the printing system.
Check if the reading value of the pressure is normal.
Normally the value of the negative pressure reads -3.8KPa.
But various slightly in different models and locations.
Adjust the pressure in the TOPJet software.
Activate the air blower and turn on the corresponding suction sector of the platform
where the media laid.
Activate the UV lamp and start the normal printing job.
See 错误！未找到引用源。 for detail information
If ever encountered with an alert or an error message.
Refer to the Troubleshooting chapter.
1.2 Printer shutdown operation
Print the nozzle test on an A4-size paper and compare with the previous one.
Turn off the air blower and the UV lamps.
Verify that the negative pressure is normal and the automatic spray function is
activated.
Shutdown the computer.
Clean the printer and the workplace.
If any nozzles missing is observed, execute the exhausting operation immediately.
See 4.10 Air exhausting of the printhead
To Next Page
Loading...