Hantek 6022BE - Page 45

Hantek 6022BE
Preshoot: Positive Overshoot = (Max - Top)/Amp x 100 %, Measured over the
entire waveform
Overshoot: Negative Overshoot = (Base - Min)/Amp x 100 %, Measured over
the entire waveform
Period: Time to take for the first signal cycle to complete in the waveform
Frequency: Reciprocal of the period of the first cycle in the waveform
Rise Time: Time taken from lower threshold to upper threshold
Fall Time: Time taken from upper threshold to lower threshold
+Duty Cycle: Positive Duty Cycle = (Positive Pulse Width)/Period x 100%,
Measured of the first cycle in waveform
-Duty Cycle: Negative Duty Cycle = (Negative Pulse Width)/Period x 100%,
Measured of the first cycle in waveform
+Pulse Width: Measured of the first positive pulse in the waveform. The time
between the 50% amplitude points
-Pulse Width: Measured of the first negative pulse in the waveform. The time
between the 50% amplitude points
1.
To measure the frequency and “Vpp”, you can do these steps as follows:
2.
Click the button, the frequency of the signal display on the
bottom of the waveform interface.
3.
Click the button, the “Vpp” of the signal will also display
on the bottom of the waveform interface.
4.
To clear the measurement on the waveform interface, click the button.
The results of measure display in Information output.
42
The User’s Manual