Safety requirements
EN
Copyright © Qingdao Hantek Electronics Co., LTD HDG3000B User manual
5
instrument:
1) Using a lint-free cloth to remove the dust from the outside of the oscilloscope and
probe. Please be careful to avoid scratching the smooth display filter material.
2) Using a soft cloth soaked with water to clean the oscilloscope. For more thoroughly
clean, use 75% isopropyl alcohol aqueous solvent
Note:
To avoid damage to the oscilloscope or the surface of the probe, please do not
use any corrosive reagent or chemical cleaning reagent.
Warning:
Before repowering, please make sure the instrument is completely dry, to avoid
electrical short circuit or even personal injury caused by moisture.
1.6 Environmental Precautions
The following sign indicates that this product conforms to the requirements set out by the
WEEE Directive 2002/96/EC.
Equipment recycling:
Producing the instrument requires the extraction and use of natural resources. Some
substances contained in the instrument may be harmful to the environment or human
health if the product is not disposed of properly. To avoid the release of harmful
substances into the environment and reduce the use of natural resources, it is
recommended that appropriate methods be used to recycle this product to ensure that
most of the materials can be correctly reused.
To Next Page
Loading...
Need help?
General
