Remote Control
EN
HDG3000B User manual Copyright © Qingdao Hantek Electronics Co., LTD
76
14 Remote Control
The HDG3000B can be controlled remotely through the following two methods.
Use PC software
Users can use the PC software to send commands to remotely control the instrument.
You can download the software from our official website.
User-defined programming
Users can program and control the instrument by using the SCPI (Standard Commands
for Programmable Instruments) commands. For more information about the commands
and programming, refer to the SCPI protocol manual.
HDG3000B can communicate with PC through USB. This chapter will give a detailed
introduction of how to use software to control HDG3000B remotely through the real USB
port.
⚫ Install Keysight IO libraries suite
⚫ Remote Control via USB
14.1 Install Keysight IO libraries suite
Users can download the application software package on the official website of Hantek:
http://hantek.com/products/detail/17187
Or click the following website to download latest one：
http://www.keysight.com/main/software.jspx?ckey=2175637&id=2175637&nid=-111
43.0.00&lc=eng&cc=GB
Double click the icon to start installing.
Click ‘Next’ to continue.
To Next Page
Loading...
Need help?
General
