Utility
EN
Copyright © Qingdao Hantek Electronics Co., LTD HDG3000B User manual
75
13.3.7 Save Picture
Users can store the content displayed on the screen in an external storage device in the
form of pictures.
First, please connect the USB stick (FAT32 format, storage space is less than or equal
to 32G) and insert the USB stick into the USB port on the front panel of the instrument.
After successful connection, the corresponding prompt message pops up on the screen.
Then enter the interface that you need to save, and press [Utility] button, the
instrument completes the screenshot and enters the Utility menu. At this time, the signal
generator has cached the screenshot inside the instrument. Press SavePic softkey, and
the instrument will save the screenshot to the USB stick.
Note: The screenshot cached is always the screen at the last time the [Utility]
button was pressed.
13.4 Firmware Update
Copy the firmware to a USB stick (FAT32 format, storage space is less than or equal to
32GB) and insert the USB stick into the USB port on the front panel of the instrument.
Press [Utility] > Update softkey, enter the file browser interface, use the knob to select
the firmware file, press Recall softkey to specify the file, and then press OK softkey to
start the firmware update.
To Next Page
Loading...
Need help?
General
