Store
EN
Copyright © Qingdao Hantek Electronics Co., LTD HDG3000B User manual
69
Refresh.
New File
In Store interface, rotate the knob to select home disk or usb disk, and then press New
softkey to enter the filename editing interface, as shown in the figure below.
Figure 12.2 New File Interface
1. Press Type softkey to select "File".
File: Create a new state file.
Directory: Create a new directory.
2. Press Swi Focus softkey and select Name or Keypad.
Name: Put the cursor in the Filename Input Area. Use direction keys to move the
cursor position and specify the location of the modified character.
Keypad: Put the cursor in the Virtual Keyboard. Rotate the knob to move the cursor
position and press down the knob to input the character. In the virtual keyboard,
rotate the knob to select Caps and press down to switch between uppercase and
lowercase; rotate the knob to select Shift and press down to switch some symbols.
3. Press Back softkey to remove the characters in front of the cursor one by one.
4. Press Delete softkey to delete all the characters in the Filename Input Area.
5. After entering the file name in the Filename Input Area, press Save softkey to save
the state file.
6. Press Return softkey to exit the New menu and return to the previous menu.
Save
Press Save softkey to automatically create a new state file and save it.
Recall
Press Recall softkey to recall the state file or arbitrary waveform file.
Rename
To Next Page
Loading...
Need help?
General
