Programmable Temperature & Humidity Controller
22
Before starting
1. Checking of components
Many thanks for buying the Hanyoung Nux temperature/humidity controller TH510! The
temperature/humidity controller TH510 is designed to control the temperature and humidity
in thermo-hydrostats. It consists of display and control units The display can be attached to
a panel or VESA-mounted and is connected to the control for communication. The control
consists of power, control, and input/output modules and can be fixed on DIN rail or attached
on a panel using screws. The operation manual describes product functions, how to install,
cautions, and how to use. Read and understand this document before starting the product.
Make sure that this operation manual will be delivered to an end user and kept in an
accessible location (This operation manual may be subject to changes for improvement and
functional changes without prior notice).
First of all, check the specifications referring to your order and see if there is any exterior damage or
missing component.
▶ Component
Display(TH510-1) Power module(TM-PWR) Control module(TH510-MAIN)
Input module(TM-DI) Output module(TM-DO) Input/output module(TM-DIO)
Communication
cable(1.5 m)
Bracket 4EA
250 Ω resistor
2EA
3P communication
Connector
SD card
Operation
manual
هﺮﮐ ﮓﻧﺎﯿﻧﺎﻫ تﻻﻮﺼﺤﻣ یرﺎﺼﺤﻧا هﺪﻨﯾﺎ ناﻮﯿﺳ ﺖﮐﴍ
To Next Page
Loading...
Need help?
General
