Programmable Temperature & Humidity Controller
78
Test mode is to test calibration
before shipment.
Caution
Screen for upgrading firmware and entering test mode. This screen is not available during operation.
To access this screen, the password is required. (Default password : 0)
▶ Firmware upgrade
Fig. 125) Firmware upgrade
Fig. 126) Firmware upgrade input pane
Access firmware upgrade pane.
Displays upgrade file name.
•You may not escape from this screen. You must reboot the display and control module.
•User attention is required for upgrading firmware so make sure to set the password.
Default password is "0". Upgrade files can be downloaded from "Hanyoung Nux" website. Do not change a file name
and place it in TH510_FWUP folder in the root directory of SD card to read it. If the firmware is upgraded, the
parameters are initialized.
Caution
Set a password for accessing F/W pane.
Compensate the small temperature hunting
within the set temperature range.
Compensate the small humidity hunting
within the set humidity range.
If set the PV HOLD value to 0 it turns off.
هﺮﮐ ﮓﻧﺎﯿﻧﺎﻫ تﻻﻮﺼﺤﻣ یرﺎﺼﺤﻧا هﺪﻨﯾﺎ ناﻮﯿﺳ ﺖﮐﴍ
To Next Page
Loading...
Need help?
General
