4.1
When unloading with an overhead lifting device, please observe the
lifting points as shown in the picture, and make sure that the straps
or belts used for lifting are strong enough.
Unloading the sprayer from the truck
General info
4 - Sprayer setup
Although the sprayer has been applied with a strong and protective surface treatment on steel parts, bolts etc. in the fac-
tory, it is recommended to apply a film of anticorrosion oil (e.g. CASTROL RUSTILLO or SHELL ENSIS FLUID) on all metal
parts in order to avoid chemicals and fertilizers discoloring the enamel. If this is done before the sprayer is put into opera-
tion for the first time, it will always be easy to clean the sprayer and keep the enamel clean for many years. This treatment
should be carried out every time the protection film is washed off
Support jack
The support jack is stored in retracted position and secured by the
linch pin when the sprayer is attached to the tractor.
To retract the support jack: Lift the jack, then pull the linch pin out
and rotate the support jack into storage position. Replace linch pin
to secure.
Before putting the sprayer into operation
To Next Page
Loading...
Need help?
General
