AXIS4000 WHEEL ALIGNMENT SYSTEM
HAWEKA Wheel Alignment –AXIS4000
4.3 Technical data
Measuring range Measuring accuracy:
Toe measurement ± 5 degrees ± 0°05'.
Camber measurement -15 degrees to +15 degrees ± 0°05'.
Castor - 5 degrees to +18 degrees ± 0°05'.
KPI -10 degrees to +20 degrees ± 0°15'.
Max. steering angle ± 70 degrees ± 0°20'.
Axle offset ± 30 mm ± 2 mm
Out of square ± 15 degrees ± 0°05'
Operating temperature +5 to +40 degrees Celsius
Shock resistance of the sensors 3500 g (inclination sensor)
2000 g (Gyro)
Wireless module:
Frequency range 2,4 GHz Band (2405 – 2480 MHz)
Automatic frequency correction
Number of channels 10
Transmitting power 10 mW
Camera:
Power supply: Lithium Ion battery pack:
18650 CF 2S1P 7,4 V / 2250 mAh
Operating time with fully charged batteries > 10 h
Charging unit:
Operating voltage 100 - 240 Volt
Turning plates
Load-bearing capacity 6 to. / each
4.4 PC system requirements for the AXIS4000
Required operating system: Windows XP, Windows 7, 8.1, 10
Necessary minimum hardware requirements:
Processor: Pentium IV – AMD Athlon 1 GHz
RAM: 512 MB (Windows XP) / 2048 MB (Windows 7, 8.1, 10)
Available hard disk space 100 MB
Graphics: Resolution 1024 x 768 pixel / high colour
Sound card
Port: USB 1.1
Recommended:
Processor: Pentium or AMD with 1.6 GHz or bigger
RAM: 2048 MB
Graphics card with AMD (ATI) or n-VIDIA chip set from 16 MB
Resolution 1280 x 1024 pixel / true colour
WLAN (option for portable handheld)
Printer
To Next Page
Loading...