AXIS4000 WHEEL ALIGNMENT SYSTEM
HAWEKA Wheel Alignment –AXIS4000
8 Preparations for measurement
Before the measurement can begin, some preparatory work must be carried out at the
measuring site and on the vehicle. This work can vary and is in some cases stipulated by
the vehicle manufacturer.
The following checklist is intended to help the user observe the various requirements:
• Check the vehicle to ensure that the rims and tyre sizes are all the
same
• Check for adequate tyre tread
• Tyre wear!! Is there any noticeable, uneven tyre wear?
• Check the correct tyre inflation pressure
• Check for any play in the steering and wheel bearings
• Check the steering joints/king pins
• Check the condition of the springs and shock-absorbers
• Note the manufacturer's specifications for different loads in order to
simulate driving conditions.
• Remove the wheel nut covers and/or hubcaps
• Clean the wheel rims between the wheel nuts so that the magnetic
feet ensure correct positioning of the camera holder on the rim.
To Next Page
Loading...