HBM GEN3i - Page 8

10.4 Trigger add-ons 154
10.4.1 Slope detector 154
10.4.2 Pulse detector 155
10.4.3 Hold off 156
10.4.4 Interval timer 157
10.4.4.1 Interval timer - Less 157
10.4.4.2 Interval timer - More 158
10.4.4.3 Interval timer - Between 159
10.4.4.4 Interval timer - NotBetween 160
10.4.5 Event counter 161
10.5 Recorder and system trigger 162
10.6 Channel alarm 164
11 Interface/Controller 165
11.1 Introduction 165
11.2 Communication and control 166
11.2.1 Network protocols and ports 167
11.2.2 Using the 1 Gbit option connections 168
11.3 Master/Slave Synchronization 169
11.3.1 Connecting the Master/Slave Synchronization connector 173
11.3.2 Connecting multiple mainframes using the Master/Slave card 173
11.3.3 Setting the Master/Slave operating modes 176
11.3.4 Setting the Master/Slave trigger 178
11.3.5 Synchronizing a Master/Slave setup to external time sources 181
11.4 I/O connector 182
11.4.1 I/O connector input overvoltage protection 183
11.4.2 I/O connector functions and connector pinning 184
11.5 Option - Optical 1 Gbit Ethernet interface 188
11.6 Option - 10 Gbit Ethernet interface 190
11.6.1 Installing a 1 Gbit SFP/10 Gbit SFP+ Module 197
11.6.1.1 Introduction 197
11.6.1.2 Warnings 197
11.6.1.3 Installation steps 199
11.7 Option - IRIG and IRIG/GPS time synchronization 203
11.7.1 GPS Antenna System Rules 204
11.7.1.1 Rule 1: Antenna placement 204
11.7.1.2 Rule 2: Is a GPS line amplifier needed? 205
11.7.1.3 Rule 3: Lightning arrestors 205
GEN3i
8 I3763-3.1 en HBM: public