HBM GEN3i - Page 7

7.4.2 To turn the feet in: 105
7.5 Probe calibration 106
7.6 DC power output 108
7.7 Digital Event/Timer/Counter 110
7.7.1 Isolated event adapter 114
7.7.2 Torque/RPM adapter 115
8 Getting Started 118
8.1 Front panel control 118
8.2 Getting started 121
8.3 Wireless network 122
8.3.1 Windows® 7: To connect GEN3i to the local wireless network: 123
8.3.2 Windows® 7: To disconnect GEN3i from the local wireless network: 124
8.3.3 Windows® 10: To connect GEN3i to the local wireless network: 125
8.3.4 Windows® 10: To disconnect GEN3i from the local wireless network: 129
9 Acquisition and Storage 131
9.1 Introduction 131
9.2 Recording 132
9.3 Storage 133
9.3.1 More on sweeps 134
9.3.2 Pre-trigger sweeps 135
9.3.3 More on continuous data storage 137
9.4 Time base 139
9.4.1 Real-time sampling and time base 139
9.4.2 Time base settings for FFTs 140
9.4.2.1 Additional information 142
10 Digital Trigger Modes 143
10.1 Introduction 143
10.2 Understanding digital triggering 144
10.2.1 Digital trigger detector 144
10.2.2 Valid trigger conditions 146
10.3 Trigger modes 148
10.3.1 Basic trigger mode 148
10.3.2 Dual trigger mode 149
10.3.3 Window trigger mode 150
10.3.4 Dual-window trigger mode 151
10.3.5 Sequential trigger mode 152
10.3.6 Trigger qualifier 153
GEN3i
I3763-3.1 en HBM: public 7