10
PME-MP85
A0897−3.4 enHBM
2 Commissioning
To prepare the MP85 measurement system for a measurement task, the
following conditions must be met or the relevant steps taken:
• You need a PME module MP85 or MP85DP and the PME Assistant,
including software
• The hardware must be configured (transducer, device, PC with the
software) (from Page 16)
• The PME Assistant software must be installed (from Page 18)
• To connect the PME module to a PC, you need a CAN adapter (from Page
17)
− PCAN parallel interface LPT to CAN or
− PCAN USB to CAN or
− PCAN card (PCI or ISA) to CAN
• The PME module must be connected to the CAN adapter
• Once you have started the software, you can set up the PME module with
the PME Assistant (Online Help) (Page 19)
To Next Page
Loading...
