HBM MP85 - Connecting the CAN Adapter (LPT and USB)

17
PME-MP85
A0897−3.4 en HBM
2.2.2 Connecting the CAN adapter (LPT and USB)
To enable PME devices to communicate with the PC, you first have to link the
device to the PC.
1. Connecting LPT to CAN (parallel interface)
• Switch off the PC and attach the LPT to CAN adapter to the parallel
interface port of the PC.
Unfortunately it is not possible to operate a printer from this parallel
interface at the same time. You need a second parallel interface.
• Attach the cable on the adapter between the male connector of the PS2
mouse and the female connector of the PC. This cable is needed to supply
power for the adapter. Alternatively you can attach this power supply cable
between the keyboard connector and the relevant PC socket.
• Attach the CAN connector cable to the MP85 to the adapter.
• Activate the PC.
2. Connecting USB to CAN
First install the PME Assistant.
• Attach the USB to CAN adapter to a free USB interface on your PC.
• The PC will immediately detect the adapter (Plug and Play).
A floppy disk is supplied with the adapter. It includes the driver required for
installation.