HBM Spider8 - Page 116

E-34
Configuring the Spider8 with the Setup program Ý Device-specific menus
Spider8
The following table shows the choice of filter frequencies for the Spider8 and the
Spider8-30.
Sampling rate as a function of cutoff frequency:
see example on following page
Cutoff frequency f
g
(Hz) Ý
1200 600 300 150 75 40 20 10 5 2.5 1 0.5 0.25 0.1
9600 (x) (x) (x) x
4800 (x) (x) x x
3200 (x) x x x
2400 (x) x x x
1600 x x x x
1200 x x x x
800 x x x x
600 x x x x
400 x x x x
300 x x x x
200 x x x x
150 x x x x
100 x x x x
75 x x x x
60 x x x x
50 x x x x
25 x x x x
10 x x x x
5 x x x
2 x x
1 x
(x) applies for the Spider8-30: maximum possible frequency is 150Hz
Example: Spider8 in combination with Spider8-30; selected frequency 300Hz:
For the Spider8-30, 150Hz is implemented, for the Spider8, 300Hz.