HBS CDM 3201 - 8 Appendix; Technical Data

58 CDM 3201 Order No. BA 92-12-3321A Issue 19.09.08
8 Appendix
In the appendix, there is information of interest regarding technical data, spare part lists,
accessories, standards, etc.
8.1 Technical Data
Power Unit CDM 3201 (with wide range power supply)
for CD stud welding (capacitor discharge welding) according to current
standards
Welding range #4 to 7/16”, dia. 14 ga to 3/8”
(M3 to M10, dia. 2 to 10 mm)
Welding material Mild steel, stainless steel, aluminum and
brass
Welding rate 12 to 40 studs/min
(depending on application and stud dia.)
Capacitance 132,000 µF/66,000 µF*
Welding time 1 to 3 msec
Energy 3,200 Ws/1,600 Ws*
Charging voltage 50 to 220 V (stepless voltage regulation)
Primary power 85 to 265 V ~ wide range selection,
50/60 Hz, 10 AT
Power source Capacitor
Cooling type F (temperatur controlled cooling fan)
Insulation class IP 21 (not allowed to use while raining)
Operational and storage conditions According to current standards
Dimensions L x W x H 23.62” x 9.45” x 11.02” (600 x 240 x 280 mm)
without handle
Weight 59.52 lbs (27 kg)
* with change over of capacitors
8 Appendix
8.1 Technical Data