heat-timer ETS-LT - Setting the Display Contras; Resetting to Factory Default

24
|
HEAT-TIMER CORP.
059327–00 REV. C
05 STARTUP
SETTING THE DISPLAY CONTRAST
1 At the default screen, press and hold the left-most button for 5
seconds. Continue to hold the button while making adjustments.
2 Use the up and down buttons to change the contrast setting
(0–30, default = 20).
3 Release the left-most button when the desired setting is reached.
RESETTING TO FACTORY DEFAULT
To set the ETV Platinum Plus back to its original factory default settings:
1 Remove power from the ETV Platinum Plus.
2 Press and hold the two right-most buttons on the ETV Platinum Plus
while powering the control on.
3 Release the buttons when instructed to do so on the display.
4 After resetting the control, the ETV Platinum Plus will go to the
Startup menu (See “System Startup Menu” on page 25).
NOTE
The display contrast can only be changed when no alarm is active.
--- SENSOR FAULT ---
All Off
All On
BACK ▲▼ SAVE
TOTAL CLEAR STARTED
Release buttons
and
Please Wait
NON-CONDENSING
-- OUTPUT TYPE --
On/Off
2-Stage
3-Stage
4-Stage
BACK ▲▼ SAVE
NON-CONDENSING
- STAGING MODE -
LO/HI/LO/HI
LO/LO/HI/HI
BACK ▲▼ SAVE
PROVE/DHW SHARING
Prove
DHW Priority
DHW No Priority
No Priority (Summer)
BACK ▲▼ SAVE
- SETBCK/SHUTDOWN -
Shutdown/Disable
Tstat/Enable
Setback
BACK ▲▼ SAVE
NON-CONDENSING
-- OUTPUT TYPE --
On/Off
2-Stage
3-Stage
4-Stage
BACK ▲▼ SAVE
NON-CONDENSING
- STAGING MODE -
LO/HI/LO/HI
LO/LO/HI/HI
BACK ▲▼ SAVE
PROVE/DHW SHARING
Prove
DHW Priority
DHW No Priority
No Priority (Summer)
BACK ▲▼ SAVE
- DHW SETPOINT -
180
o
F
[ ]
BACK ▲▼ SAVE
--- SENSOR FAULT ---
All Off
All On
BACK ▲▼ SAVE
TOTAL CLEAR STARTED
Release buttons
and
Please Wait
NON-CONDENSING
-- OUTPUT TYPE --
On/Off
2-Stage
3-Stage
4-Stage
BACK ▲▼ SAVE
NON-CONDENSING
- STAGING MODE -
LO/HI/LO/HI
LO/LO/HI/HI
BACK ▲▼ SAVE
PROVE/DHW SHARING
Prove
DHW Priority
DHW No Priority
No Priority (Summer)
BACK ▲▼ SAVE
- SETBCK/SHUTDOWN -
Shutdown/Disable
Tstat/Enable
Setback
BACK ▲▼ SAVE
NON-CONDENSING
-- OUTPUT TYPE --
On/Off
2-Stage
3-Stage
4-Stage
BACK ▲▼ SAVE
NON-CONDENSING
- STAGING MODE -
LO/HI/LO/HI
LO/LO/HI/HI
BACK ▲▼ SAVE
PROVE/DHW SHARING
Prove
DHW Priority
DHW No Priority
No Priority (Summer)
BACK ▲▼ SAVE
- DHW SETPOINT -
180
o
F
[ ]
BACK ▲▼ SAVE