26
English
Remove the frame and the lower lid from the charging
system (Fig.2).
The charging system is connected via a cable fed in at
the rear as standard. Pre-cut areas are prepared which
you can break out with pliers to feed in the cable from
the top or bottom.
To feed in the cable from the top, carefully remove the
pre-cut area under (Fig.3 - no.1) using pliers or a saw.
When feeding in the cable from above, make sure that
the charging system is located in a place protected
against the weather.
To feed in the cable from the bottom, carefully remove
the pre-cut area under (Fig.3 - no.2) using pliers.
Optional
The charging system features optional data interfaces.
Toconnecttheinterfaces,e.g.DigitalIn/DigitalOutand
LAN,carefullybreakoutthepre-cutarea(Fig.3 - no.3)
using a hammer.
Fig.2
Fig.3
1
2
3
1
2
3 4 5 6 71 2
Preparing the
charging system
To Next Page
Loading...
Need help?
General
