Organization mode of operation | Parameters
9
622
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
Settings for fixed cycles and units
3: ZX – Sequentially
Inside safety clearance [SIBC] (602705)
[mm]: Retraction clearance for deep drilling B
Driven drilling tool [SBC] 602706)
[mm]: Safety clearance for driven tools
Non-driven drilling tool [SBCF] (602707)
[mm]: Safety clearance for tools that are not driven
Driven tap [SGC] (602708)
[mm]: Safety clearance for driven tools
Non-driven tap [SGCF] (602709)
[mm]: Safety clearance for tools that are not driven
Drilling depth factor [BTCF] (602710)
Factor for the calculation of the first drilling depth for deep drilling
Drilling depth reduction [BTRC] (602711)
[mm]: Reduction for deep drilling
Diameter tolerance for drills [BDT] (602712)
[mm]: Used for the selection of the tool for drilling
Processing
Milling (602800)
Approach/front face – milling [ANMS] (602801): Approach strategy
1: XZ – Simultaneously
2: XZ – Sequentially
3: ZX – Sequentially
Approach/lateral surface – milling [ANMM] (602802): Approach strategy
1: XZ – Simultaneously
2: XZ – Sequentially
3: ZX – Sequentially
Departing/front face – milling [ABMS] (602803): Departing strategy
1: XZ – Simultaneously
2: XZ – Sequentially
3: ZX – Sequentially
Departing/lateral surface – milling [ABMM] (602804): Departing strategy
1: XZ – Simultaneously
2: XZ – Sequentially
3: ZX – Sequentially
To Next Page
Loading...
