HEIDENHAIN TNC 320 - New functions

Fundamentals | Control model, software and features
HEIDENHAIN | TNC 320 | ISO Programming User's Manual | 10/2017
11
New functions
New functions 34055x-06
The active tool-axis direction can now be activated as a virtual
tool axis in the Manual Operation mode and during handwheel
superimpositioning, see "Superimposing handwheel positioning
during program run: M118 ", page 439
Writing and reading data in freely definable tables, see "Freely
definable tables", page 463
New touch probe Cycle 484 for calibrating the wireless touch
probe TT 449, see Cycle Programming User's Manual
The new HR 520 and HR 550 FS handwheels are supported,
see "Traverse with electronic handwheels", page 519
New operating Cycle 225 Engraving,
see Cycle Programming User's Manual
New manual probing cycle Center line as preset, see "Setting a
center line as preset", page 569
New function for rounding corners, see "Rounding corners:
M197", page 446
External access to the control can now be blocked with an MOD
function, see "External access", page 628