Fundamentals | Control model, software and features
8
HEIDENHAIN | TNC 320 | ISO Programming User's Manual | 10/2017
Control model, software and features
This manual describes functions and features provided by controls
as of the following NC software numbers.
Control model NC software number
TNC 320 771851-05
TNC 320 Programming Station 771855-05
The machine manufacturer adapts the usable features of the
control to his machine by the setting machine parameters. Some of
the functions described in this manual may therefore not be among
the features provided by the control on your machine tool.
Control functions that may not be available on your machine
include:
Tool measurement with the TT
In order to find out about the actual features of your machine,
please contact the machine manufacturer.
Many machine manufacturers, as well as HEIDENHAIN, offer
programming courses for the HEIDENHAIN controls. Participation
in one of these courses is recommended to familiarize yourself
thoroughly with the control's functions.
Cycle Programming User's Manual:
All of the cycle functions (touch probe cycles and fixed
cycles) are described in the Cycle Programming User's
Manual. If you need this user's manual, please contact
HEIDENHAIN if required. ID: 1096959-xx
To Next Page
Loading...
