Programming Q Parameters | Additional functions
9
HEIDENHAIN | TNC 320 | ISO Programming User's Manual | 10/2017
353
D14: Displaying error messages
With the D14 error function, you can output error messages under
program control. The messages are predefined by the machine
tool builder or by HEIDENHAIN. If, during a program run or test
run, the control encounters a block with D14, then the control will
interrupt the program run or test run and display an error message.
The program must then be restarted.
Error numbers area Standard dialog
0 ... 999 Machine-dependent dialog
1000 ... 1199 Internal error messages
Example
The control is intended to display a message if the spindle is not
switched on.
N180 D14 P01 1000*
Error message predefined by HEIDENHAIN
Error number Text
1000 Spindle?
1001 Tool axis is missing
1002 Tool radius too small
1003 Tool radius too large
1004 Range exceeded
1005 Start position incorrect
1006 ROTATION not permitted
1007 SCALING FACTOR not permitted
1008 MIRROR IMAGE not permitted
1009 Datum shift not permitted
1010 Feed rate is missing
1011 Input value incorrect
1012 Incorrect sign
1013 Entered angle not permitted
1014 Touch point inaccessible
1015 Too many points
1016 Contradictory input
1017 CYCL incomplete
1018 Plane wrongly defined
1019 Wrong axis programmed
1020 Wrong rpm
1021 Radius comp. undefined
To Next Page
Loading...
