HEIDENHAIN TNC 320 - 11.3 Defining DIN;ISO functions; Overview

Special Functions | Defining DIN/ISO functions
11
456
HEIDENHAIN | TNC 320 | ISO Programming User's Manual | 10/2017
11.3 Defining DIN/ISO functions
Overview
If a USB keyboard is connected, you can also directly
type in the DIN/ISO functions on the keyboard.
The control provides soft keys with the following functions for
creating DIN/ISO programs:
Soft key Function
Select ISO functions
Feed rate
Tool movements, cycles and program functions
X coordinate of the circle center/pole
Y coordinate of the circle center/pole
Label call for subprogram and program section
repeat
Miscellaneous function
Block number
Tool call
Polar coordinate angle
Z coordinate of the circle center/pole
Polar coordinate radius
Spindle speed