Fundamentals | Control model, software and features
18
HEIDENHAIN | TNC 320 | ISO Programming User's Manual | 10/2017
New functions 77185x-04
New function FUNCTION DWELL for programming a dwell time,
see "Dwell time FUNCTION DWELL", page 473
New function FUNCTION S-PULSE for programming pulsing
shaft speeds, see "Pulsing spindle speed FUNCTION S-PULSE",
page 469
The column KINEMATIC has been added to the tool table, see
"Entering tool data into the table", page 208
The column OVRTIME has been added to the tool table, see
"Entering tool data into the table", page 208
When importing tool data the CSV file may contain additional
table columns not recognized by the control. During import a
message is displayed indicating the unrecognized columns and
informing that these values will not be adopted, see "Importing
and exporting tool data", page 241
Manual probe functions create a line in the preset management
if the specified line does not exist yet, see "Writing measured
values from the touch-probe cycles to the preset table",
page 548
Manual probe functions can write in a password-protected line,
see "Recording measured values from the touch probe cycles",
page 546
During a manual touch probe cycle, control can be transferred
to the handwheel, see "Traverse movements with a handwheel
with display", page 542
Several handwheels can be connected to a control, see
"Traverse with electronic handwheels", page 519
In Electronic handwheel mode of operation, the handwheel
axis for an HR 130 can be selected with the orange axis keys
If the control is set to the INCH unit of measure, the control also
includes movements traversed by the handwheel in INCHES,
see "Traverse with electronic handwheels", page 519
The control differentiates between interrupted or stopped NC
programs. In the interrupted status, the control offers more
intervention options, see "Interrupting, stopping or aborting
machining", page 605
The software option number 42 DXF Converter now also
produces CR circles, see "Basic settings", page 299
With active structuring the structure block can be edited in the
structure window, see "Definition and applications", page 179
Animated help can be selected with the tilt working plane
function, see "Overview", page 481
The D18 functions have been expanded, see "D18 – Reading
system data", page 363
The D16 functions have been expanded, see "D16 – Formatted
output of texts and Q parameter values", page 357
The file saved with SAVE AS is now also found in the file
management under LAST FILES, see "Editing an NC program",
page 136
If you save files with SAVE AS, you can select the target
directory with the SWITCH soft key, see "Editing an NC
program", page 136
To Next Page
Loading...
