HEIDENHAIN TNC 320 - Starting the test run

First Steps with the TNC 320 | Graphically testing the first part
1
70
HEIDENHAIN | TNC 320 | ISO Programming User's Manual | 10/2017
Starting the test run
Press the RESET + START soft key
The control resets the previously active tool data
The control simulates the active program up to a
programmed break or to the program end
While the simulation is running, you can use the
soft keys to change views
Press the STOP soft key
The control interrupts the test run
Press the START soft key
The control resumes the test run after a break
Further information on this topic
Performing a test run
Further information: "Test run", page 599
Graphic functions
Further information: "Graphics ", page 586
Adjusting the simulation speed
Further information: "Speed of the setting test runs",
page 587