Manual Operation and Setup | Managing presets
13
HEIDENHAIN | TNC 320 | ISO Programming User's Manual | 10/2017
537
Activating a preset
Activate a preset in the Manual operation mode
NOTICE
Caution: Significant property damage!
Undefined fields in the preset table behave differently from
fields defined with the value 0: Fields defined with the value 0
overwrite the previous value when activated, whereas with
undefined fields the previous value is kept.
Before activating a preset, check whether all columns contain
values.
Operating notes:
When activating a preset from the preset table,
the control resets any active datum shift, mirroring,
rotation, or scaling factor.
On the other hand, the Tilt working plane function
(Cycle G80 or PLANE) remains active.
Select the Manual operation mode
Press the PRESET MANAGEMENT soft key
Select the preset number that you want to
activate
Or, with the GOTO key, select the preset number
that you want to activate
Confirm with the ENT key
Press the ACTIVATE PRESET soft key
Confirm activation of the preset
The control sets the display and the basic
rotation.
Exit the preset table
Activating a preset in an NC program
Use Cycle G247 in order to activate presets from the preset table
during program run. In Cycle G247 you define the number of the
preset to be activated.
Further information: Cycle Programming User's Manual
To Next Page
Loading...
