HEIDENHAIN TNC 320 - 13.9 Presetting with a 3-D touch probe; Overview

Manual Operation and Setup | Presetting with a 3-D touch probe
13
562
HEIDENHAIN | TNC 320 | ISO Programming User's Manual | 10/2017
13.9 Presetting with a 3-D touch probe
Overview
Refer to your machine manual.
The machine tool builder can disable presetting in
individual axes.
If you try to set a preset in a locked axis, the control will
issue either a warning or an error message, depending
on what the machine tool builder has defined.
The following soft-key functions are available for setting a preset on
an aligned workpiece:
Soft key Function Page
Presetting on any axis 563
Setting a corner as preset 564
Setting a circle center as preset 566
Center line as preset
Setting the center line as preset
569
With an active datum shift the determined value is with
respect to the current preset (possibly a manual preset
from the Manual operation mode). The datum shift is
included in the position display.