Manual Operation and Setup | Moving the machine axes
13
HEIDENHAIN | TNC 320 | ISO Programming User's Manual | 10/2017
517
13.2 Moving the machine axes
Note
Refer to your machine manual.
Movement of the axes via the axis direction keys can
vary depending on the machine.
Moving the axis with the axis direction keys
Operating mode: Press the Manual operation
key
Press the axis direction key and hold it down as
long as you wish the axis to move; or
To move the axis continuously: Press and hold
the axis direction button and press the NC Start
key
To stop: Press the NC Stop key
You can move several axes at a time with these two methods. The
control then shows the feed rate. You can change the feed rate at
which the axes are moved with the F soft key.
Further information: "Spindle speed S, feed rate F and
miscellaneous function M", page 529
If a moving task is active on the machine, the control displays the
control in operation symbol.
To Next Page
Loading...
