HEIDENHAIN TNC 320 - Comparison: Probing system cycles for automatic workpiece control

Tables and Overviews | Functions of the TNC 320 and the iTNC 530 compared
17
698
HEIDENHAIN | TNC 320 | ISO Programming User's Manual | 10/2017
Comparison: Probing system cycles for automatic
workpiece control
Cycle TNC 320 iTNC 530
0 REF. PLANE
X X
1 POLAR PRESET
X X
2 CALIBRATE TS
– X
3 MEASURING
X X
4 MEASURING IN 3-D
X X
9 CALIBRATE TS LENGTH
– X
30 CALIBRATE TT
X X
31 CAL. TOOL LENGTH
X X
32 CAL. TOOL RADIUS
X X
33 MEASURE TOOL
X X
400 BASIC ROTATION
X X
401 ROT OF 2 HOLES
X X
402 ROT OF 2 STUDS
X X
403 ROT IN ROTARY AXIS
X X
404 SET BASIC ROTATION
X X
405 ROT IN C AXIS
X X
408 SLOT CENTER PRESET
X X
409 RIDGE CENTER PRESET
X X
410 PRESET INSIDE RECTAN
X X
411 PRESET OUTS. RECTAN
X X
412 PRESET INSIDE CIRCLE
X X
413 PRESET OUTS. CIRCLE
X X
414 PRESET OUTS. CORNER
X X
415 PRESET INSIDE CORNER
X X
416 PRESET CIRCLE CENTER
X X
417 PRESET IN TS AXIS
X X
418 PRESET FROM 4 HOLES
X X
419 PRESET IN ONE AXIS
X X
420 MEASURE ANGLE
X X
421 MEASURE HOLE
X X
422 MEAS. CIRCLE OUTSIDE
X X
423 MEAS. RECTAN. INSIDE
X X
424 MEAS. RECTAN. OUTS.
X X
425 MEASURE INSIDE WIDTH
X X
426 MEASURE RIDGE WIDTH
X X
427 MEASURE COORDINATE
X X